Skip Headers
Oracle® Access Manager for AS/400 Installation and User's Guide
10g Release 2 (10.2) for IBM iSeries OS/400

Part Number B16223-01
Go to Documentation Home
Home
Go to Book List
Book List
Go to Table of Contents
Contents
Go to Index
Index
Go to Master Index
Master Index
Go to Feedback page
Contact Us

Go to previous page
Previous
Go to next page
Next
View PDF

3 System Requirements

This chapter describes the hardware and software requirements of the Oracle Access Manager for AS/400. It includes the following sections:

3.1 Hardware Requirements

Oracle Access Manager for AS/400 requires the following hardware:

3.1.1 Processor

The Oracle Access Manager for AS/400 requires an AS/400 processor that supports any current version of OS/400. Also refer to Section 3.2.1, "Operating System", under Software Requirements.

3.1.2 CD-ROM Drive

The Oracle Access Manager for AS/400 is distributed on a CD-ROM.

3.1.3 Disk Space

You should have at least 400 MB of free disk space available before beginning the installation of this product. At the end of the installation there will be approximately 52 MB of objects in the install library. There will be another 149 MB of objects in an Oracle Service Program Library which will have a name similar to ORASRVnnnn where the nnnn are numeric digits. Multiple installations of the Access Manager at the same level share a common Oracle Service Program Library. An installation of the Oracle Transparent Gateway at the same version level as the Access Manager will also share the same Oracle Service Program Library.

3.2 Software Requirements

Oracle Access Manager for AS/400 requires the following software:

3.2.1 Operating System

The Oracle Access Manager for AS/400 runs in OS/400 V5R2 or V5R3.

3.2.2 Communications

The Oracle Access Manager for AS/400 requires a TCP/IP connection to the target Oracle server.

3.2.3 Oracle Server

Any supported release of the Oracle server is supported by the Oracle Access Manager for AS/400. To be supported, the Oracle server must be configured with TCP/IP access.

3.2.4 PTF Requirements

For OS/400 V5R2, PTFs SI09769 and SI09772 should be applied. Oracle recommends that you keep up to date with the latest DB2/400 PTF group. You can check your current PTF status using the WRKGRPPTF command. For OS/400 V5R2 use WRKGRPPTF SF99502 and for OS/400 V5R3, use WRKGRPPTF SF99503.

3.2.5 Additional Software

You must have the SQL Development Kit (IBM Program Number 5722-ST1) installed in order to run STRSQL and to develop embedded SQL programs.

3.3 Recommended Documentation

The following documents might be useful in providing additional information about products that are used with the Oracle Access Manager for AS/400: