This screenshot shows Step 3 of 3 in the Add Standby Database process of adding an existing RAC standby database. Near the top of this screenshot is a timeline indicating which step you are at in the process. As you proceed through the Add Standby Database process, the timeline will advance appropriately.

The third step in adding an existing RAC standby database is to review the data that you input for the configuration before clicking Finish. The left side of the screenshot provides information about the primary database. The right side of the screenshot provides information about the standby database.

At this time, you have four choices. You can click Cancel, Back, or Finish. If you click Cancel, you terminate the current process and must begin again at the introductory page of the Add Standby Database wizard. This scenario assumes you are finishing the process.